COMPREHENSIVE CONTROL SOLUTIONS

Control elements which increase convenience and easy of using air heaters and air curtains to provide comfort climate inside as well as save energy and extend equipment life time.

CONTROL ELEMENTS

RTS 10

RTS 10 – is a panel for switching temperature and fan rotation speeds.

  • Convenient control of temperature with 1.0°C accuracy
  • Temperature control range +5°С ... +30°С
  • Manual mode of control of rotation speed of three-speed AC-fan
  • Control of required temperature
  • Noise reduction
  • Operation at heating and cooling modes
  • Possibility of operation with valve with actuator SRV
  • Protection class IP20
  • Weight (net/gross) – 0.19/0.23 kg
  • Net dimensions (WхHхL) – (85х130х42) mm
  • Gross dimension (WхHхL) – (90х133х50) mm           

RTS 30

RTS 30 – is a programmable controller of temperature and AC-fan rotation speed. 

  • Programmability of temperature mode with accuracy up to 0.5°C
  • Temperature control range+5°С ... +70°С
  • Automatic and manual modes of control of rotation speed of three-speed AC-fan
  • Week programmability 5+1+1
  • Can be used with RC 30 remote controller
  • Possibility of operation with door switch DC 230 
  • Possibility to connect thermal sensor NTC 65
  • High level of energy savings
  • Protection against indoor temperature drop lower than critical level
  • Operation at heating and cooling modes
  • MODBUS protocol
  • Possibility of operation with valve with actuator SRV 2
  • Protection class IP20
  • Weight (net/gross) – 0.21/0.30 kg
  • Net dimensions (WхHхL)– (138х94х36) mm
  • Gross dimension (WхHхL) – (156х120х46) mm             

RTS 40

RTS 40 – is a programmable controller of temperature and AC-fan rotation speed.

  • Programmability of temperature mode with accuracy up to 0.5°C
  • Temperature control range+5°С ... +70°С
  • Automatic and manual modes of control of rotation speed of three-speed AC-fan
  • Week programmability 5+1+1
  • Can be used with RC 30 remote controller
  • Possibility of operation with door switch DC 230 
  • Possibility to connect thermal sensor NTC 65
  • High level of energy savings
  • Protection against indoor temperature drop lower than critical leve
  • Operation at heating and cooling modes
  • MODBUS protoco
  • Possibility of operation with valve with actuator SRV 2
  • Protection class IP20
  • Weight (net/gross) – 0.21/0.30 kg
  • Net dimensions (WхHхL)– (138х94х36) mm
  • Gross dimension (WхHхL) – (156х120х46) mm             

ECP 220

ECP 220 – is a programmable controller of temperature and EC-fan rotation speed. 

  • Programmability of temperature mode with accuracy up to 0.5°C
  • Temperature control range +5°С ... +70°С
  • Automatic or manual modes of control of rotation speed of a EC motor/a group of EC motors
  • Week programmability 5+1+1
  • Can be used with RC 30 remote controller
  • Possibility of operation with door switch DC 230
  • Possibility to connect thermal sensor NTC 65
  • High level of energy savings
  • Protection against indoor temperature drop lower than critical level
  • Operation at heating and cooling modes
  • MODBUS protocol
  • Possibility of operation with valve with actuator SRV 
  • Protection class IP20
  • Weight (net/gross) – 0.20/0.29 kg
  • Net dimensions (WхHхL) – (138х94х36) mm
  • Gross dimension (WхHхL) – (155х120х46) mm 

SRV

SRV – is a two-way valve with actuator allows to control the flow of coolant in automatic mode from a programmable controller or mechanical remote control.

  • Valve тype - Normally Opened
  • Energy savings
  • Protection class IP54
  • Power supply 230 V/50 Hz
  • Weight (net/gross) – 0.42/0.46 kg
  • Net dimensions (WхHхL) – (90х105х40) mm
  • Gross dimension (WхHхL) – (105х100х70) mm   

SRV 2

SRV 2 – is a two-way valve with actuator allows to control the flow of coolant in automatic mode from a programmable controller or mechanical remote control.

  • Valve тype - Normally Closed
  • Energy savings
  • Protection class IP54
  • Power supply 230 V/50 Hz
  • Weight (net/gross) – 0.42/0.46 kg
  • Net dimensions (WхHхL) – (90х105х40) mm
  • Gross dimension (WхHхL) – (105х100х70) mm   

SRVK

SRVK – is a three-way valve with actuator SRVK is continuously adjustable with a 0-10 V signal, which gives the VKT / VKT EC control board.

  • Smooth regulation
  • Low noise Precise
  • positioning 

POWER BOX

POWER BOX – is a board to regulate fan motors. It is controlled by signals from RTS 10 or RTS 30.

  • Ease of adjustment and accurate control
  • Can provide control of up to 9 air heaters (AC)
  • High efficiency
  • Protection class IP65
  • Weight (net/gross) – 1.35/1.40 kg
  • Net dimensions (WхHхL) – (240x190x100) mm
  • Gross dimension (WхHхL) – (240x190x100) mm    

POWER BOX EC

POWER BOX EC – is a board to regulate fan motors. It is controlled by signals from ECP 220.

  • Ease of adjustment and accurate control
  • Can provide control of up to 16 air heaters (EC)
  • High efficiency
  • Protection class IP65
  • Weight (net/gross) – 1.35/1.40 kg
  • Net dimensions (WхHхL) – (240x190x100) mm
  • Gross dimension (WхHхL) – (240x190x100) mm       

VKT

VKT – is a solution to control air heaters PROTON VENT VK with air supply. Operation of the control board is fully autonomous, a user only needs to set necessary speed of motor rotation (or switch to its autonomous mode) and set necessary temperature in a room. Work of the panel is based on analysis of temperature setpoint along with temperature sensors mounted inside the room, on the back side of the heat exchanger, outdoor and sending control signals to actuators of an air damper, actuator of a two-way valve and regulation of motor rotation speed. A PI-regulator creates control signals of 0-10 V basing on a controller’s data. Also choice of a working mode is performed (winter/summer). If voltage fails the air damper is closed automatically, the heat exchanger valve stays opened in order to prevent heat exchanger leakage.

  • Regulation of PROTON VENT VK operation
  • Regulation of inlet air volumes
  • Automatic control of heat medium supply
  • Automatic switch to winter/summer modes
  • Control of heat medium temperature in the heat exchanger (to prevent defrosting of the heat exchanger)
  • Control of indoor temperature
  • Possibility to connect to fire-protection alarm

VKT EC

VKT EC – is a solution to control air heaters PROTON VENT VK with air supply equipped with EC fan. Operation of the control board is fully autonomous, a user only needs to set necessary speed of motor rotation (or switch to its autonomous mode) and set necessary temperature in a room. Work of the panel is based on analysis of temperature setpoint along with temperature sensors mounted inside the room, on the back side of the heat exchanger, outdoor and sending control signals to actuators of an air damper, actuator of a two-way valve and regulation of motor rotation speed. A PI-regulator creates control signals of 0-10 V basing on a controller’s data. Also choice of a working mode is performed (winter/summer). If voltage fails the air damper is closed automatically, the heat exchanger valve stays opened in order to prevent heat exchanger leakage.

  • Regulation of PROTON VENT VK operation
  • Regulation of inlet air volumes
  • Automatic control of heat medium supply
  • Automatic switch to winter/summer modes
  • Control of heat medium temperature in the heat exchanger (to prevent defrosting of the heat exchanger)
  • Control of indoor temperature
  • Possibility to connect to fire-protection alarm

RDE

RDE – is designed to control the industrial PROTON HD P1 curtains with electric heating.

  • Regulation of up to 2 air curtains with electric heating 
  • Protection against overheating of motors and heating elements
  • Locking against accidental activation
  • It is equipped with protective circuit breakers which enables secure power lines against blowing
  • Connection of remote control
  • Connection of DC 230 door switch
  • Protection class IP54
  • Weight (net/gross) – 5.25/5.40 kg
  • Net dimensions (WхHхL) – (325x545x155) mm
  • Gross dimension (WхHхL) – (350x570x180) mm         

NTC 65

NTC 65 – is a external thermal sensor. Checks indoor temperature and sends data to a controller.

  • High accuracy
  • Possibility to connect a number of sensors for large buildings
  • Possibility to use in explosive buildings
  • Protection class IP65
  • Weight (net/gross) – 0.09/0.10 kg
  • Net dimensions (WхHхL) – (65х128х42) mm
  • Gross dimension (WхHхL) – (70х150х50) mm              

RT 10

RT 10 – thermostat.

  • Diverse ways to connect a control devise (an actuator or a fan motor with help of additional relay). 
  •  Simple and reliable construction.
  • Availability.                           

TR

TR – regulator.

  • Possibility of the group control by the same regulator.
  • Resistance to moisture and dust (IP54 protection grade).
  • Lowering the sound pressure level by reducing the speed.                       

RC 30

RC 30 – is a remote controller.

  • Optional for programmable controllers ECP 220, RTS 30, RTS 40.

DC 230

DC 230 – is a device designed for automatic turn on of the mechanism (a curtain) when a moving part (door) reaches a certain place.

  • Control of door position of other moving elements 
  • Supply of signal to on/off the curtain PROTON HD
  • Protection grade of the casing is IP65
  • Mechanical wear-resistance is 1 000 000 hours